Directions

All surfaces to be bonded must be clean, dry and free of contaminants such as dust, sand, oil and grease films.

For satisfactory bonding, follow the procedure:

1. 1. Stir contents of container thoroughly before use. Do not dilute to make volume.
   2. Surface should be free of dust, sand or foreign matter.
   3. Apply a uniform coat to the surface by brush, roller or spray gun.
   4. Before applying the concrete plaster, check surface for uniformity of color. Areas that are irregular in shade indicate an insufficient amount of bonding has been applied.
   5. Allow at least two hours for bonding to cure before applying concrete plaster.
   6. If cured 24 hours, apply an additional coat before applying concrete plaster.
   7. Always maintain the proper level of water in the concrete plaster mix. Do not apply too dry.
   8. When troweling the concrete plaster, use a circular motion follow through on all strokes. Never pull the trowel away perpendicular to the surface.

• Storage: Protect from freezing; store in a cool, dry place at room temperature. Product must be used within one year of purchase.
• Mixing: Always mix thoroughly by hand or with a power agitator before application.
• Cleanup: Clean all equipment immediately after use with warm soapy water. Completely flush all spray equipment with this solution.